I machined a test panel for the seat bottom today at work. It looks like I will need to move the cross brace that sits under the seat further forward to help support the rear edge of the seat bottom. I tried sitting in the seat and I think that I will need to move the forward edge of the cockpit forward a few inches as I was unable to fit my knees inside without putting a lot of weight on the fuselage sides. I will test this further once the sides and bottom are fully sheeted.
I cut and glued the motor mount reinforcement block into the rear of the fuselage tonight. Then I started to fit the side sheeting on the left rear side of the fuselage.
Number of hours: 3.6
Total hours: 123.8
No comments:
Post a Comment