I cut a hole in the tab facing spar for a control horn passageway and then I put a coat of varnish on the inside of the tab facing spar. I tried to even out the suface on one of the lengths of trailing edge that I cut a couple of months ago and then I cut a piece of plywood for the anti-tab lower surface. I think it is a little odd that the upper and lower surface of the anti-tab are 0.8mm plywood but the upper and lower surfaces of the canard are 1.2mm plywood (I will be using 1.5mm because 1.2mm is unavailable).
Number of hours: 0.7
Total hours: 246.7
No comments:
Post a Comment