I marked the location for each vertical member on the upper and lower cap strips and then cut the lower cap strip to its proper length. I trimmed the lower cap strip so they end at the outboard side of the last vertical ribs. I am not 100% sure that it was the right decision, but sometimes you have to make a judgement call and let the cards fall where they may. This will affect the way the wingtip foam is attached; for better or for worse, only time will tell. The next step was to glue the four 200mm hinge mounting block reinforcement strips to the upper and lower cap strips.
Number of hours: 0.8
Total hours: 206.6
No comments:
Post a Comment